Alternatively, if you don not have an internet connection available, you could have a computer running on site with the Dash software running on it in order to log data locally.
Equipped with software applications for calibrating meters. |Item #7250847 Litersand cubic feet are also options. Privacy&Security| Keep in mind that up to 3 water meters can be connected to the v.4 Omnimeter. You could set the Dash software to email you monthly or daily, etc., reports of your usage. We will send you an email when your question is answered by the Experts.
The RCM-100 is very unique in that it also comes standard with a pulse or encoded (Sensus protocol) output for connection the a wireless AMR system or other data collection system. The RDU-1000 contains a micro-processor that interrogates the encoder or stores counts from any pulse type metering device. Compatible withTell me More! Help us improve this article with your feedback. Touch meter reading is where the meter with typically an encoder register has a wire going to a remote magnetic coil. The meter reading is displayed on a 6-digit LCD powered by a 3.6 Volt Lithium battery delivering a service life calculated to more than 13 years. https://www.linkedin.com/showcase/fergusonwaterworks/, Elster Amco Water Electromagnetic Water Meter, The evoQ4 incorporates smart metering technology which allows it to output information for billing, network management and leakage monitoring, The technology is compatible with AMI and AMR system, Elster designed this evoQ4 mag meter to be used in potable water applications, Deliver an accurate reading in all flow conditions. 2022 For use with pulse or encoded registers Single or dual meter displays AMR Output Tamper Detection Resolves customer complaints, RDU-1000 Remote Display UnitSingle Display Cold & Dual Display Hot/Cold Units, ConstructionEnclosure: Water resistant wall mountEnclosure Material: Grey Poly-CarbonateCover Material: Clear Poly-CarbonateCircuit Board: Conformal Coated (For Moisture Resistance)Display: MARS Custom 8-Digit LCDConnection: Internal Screw TerminalDimensions: 2.5 x 4.5 x 1.5, ApprovalsState of California CTEP Approved, RDU-1000-C Single Display Cold Water Meter Remote Display UnitRDU-1000-HC Dual Display Hot & Cold Water Meter Remote Display Unit, H2O Degree3580 Progress Drive, Suite LBensalem, PA 19020, California SB7 Submetering Compliance Solutions, Wireless Water Metering & Leak Detection Products, L54120+ Battery Powered LoRaWAN Enabled Water Meter, WM-1200 Hot or Cold Water Meter 3/4, 1, 1.5 and 2 Multi-Jet, WM-1300 Cold Water Meter with Pulse Output, WM-1400 3/4 Hot or Cold Water Meter with Pulse Output, WM-1500 Hot or Cold Water Meter 3/4 Multi-Jet, WM-1800 5/8 x 3/4 and 1 Hot Water Meter with Pulse Output, WM-2000 Cold Water Meter Encoded Register, M54190 & M54191 Encoded Register Mesh Transceiver, EM-2000 Din-Rail & Multiple Meter Electric Meter, EM-6000 Multi-Circuit Electric Smart Meter, VG7000 Transceiver for EM-7000 Electric Meters, RTD1004 BTU Meter Outlet Temperature Probe, Submetering System Infrastructure & Components, M54230 Battery-Powered Two-Channel Pulse Counter, M54130 Line Powered Four Channel Pulse Counter, M54200 Line-Powered Wireless Mesh Transceiver, L54215/L54230 LoRaWAN Enabled Battery Powered One or Two Channel Pulse Counter, LIT1005 LoRaWAN Enabled Line Powered Gateway, L54110 LoRaWAN Enabled Temperature/Humidity Sensor, H2O Degree Wireless Metering, Submetering & Leak Detection Systems. Low battery indication. Pipe mounted flow meter with Remote Display supplied with a 13" long section of 1" schedule 80 PVC pipe. The easy interfacing management systems of the pulse transmitter models extend the field of application of pulse meters combined with remote displays. For the best experience on our site, be sure to turn on Javascript in your browser. Elster Amco Water Remote Display US Gallons x 1000 (Remote Display Cable Required), Elster Amco Water 30 ft. Different measurement unit settings. I agree to the processing of my personal data in accordance with Reg.
You could set the Dash software to email you monthly or daily, etc., reports of your usage. Copyright . The Push3 can be connected to an internet connection or even cellular modem as long as you have a way to plug into its RJ45 ethernet jack. We're having difficulty searching. Adigital averaging algorithm is used to minimizethe flow rate variations. Encoder meters have an electronic capable register that can be interrogated by an external device to determine the reading from the register odometer wheels or electronic read.
Please try again or. 
Sorry we couldn't be helpful.
Pulsed Cold Water Meter - 20mm, 3/4" BSP TM, Flexible Rubble Container 42 Litres - Black, Electric Meter Box Replacement Door - H 550 x W 381mm, Everbuild Jetcem Sand/Cement Premixed - 2kg Bag, Straight Filling Loop with Two Stop Valves - 15mm, Automatic By-Pass Differential Valve - 22mm Angled, Lever Handle Ball Pump Valve - 1.1/2 x 35mm Pair, Adjustable Pressure Reducing Valve - 15/22mm. Pipe mounted flow meter with Remote Display supplied with a 13" long section of 4" schedule 80 PVC pipe. 
You could connect the Omnimeter Pulse v.4 to this computer via the iSerial or our $25USB Converter. If you're using a v.4 or v.5 Omnimeter and the EKM Push system to read your water meter(s), then you can use Encompass.io to read your water meter data. https://help.ekmmetering.com/support/solutions/articles/6000068435-spec-sheets. Pollardwater Inc. All rights reserved. The LCD display consists of 21 large digits (1/2 height). Again the Omnimeter spec sheets explain how to wire this portion of the system. Get your best contracted price We can supply the VL-9 LCD remote for most encoder based output meters.
No. For each unit of water that flows by the meter produces an electrical pulse that can be measured from a distance. It is not possible to change the configuration or readings without this device. In reality these wired connections will be extended over further distances (up to 200 feet for the pulse output wires coming from the water meter, up to 4000 feet for the RS485 wires going to the EKM Push gateway). Terms of Sale| Compatible withTell me More! Hover over the Red Arrows for more Information. UE 679/2016 - GDPR. The Buna-N O-ring can be replaced with Viton as an option. Available as both basic display device and as pulse emitter. Remote Display Unit for Pulsed Water Meters. Spec Sheets: https://help.ekmmetering.com/support/solutions/articles/6000068435-spec-sheets. REMOTE DISPLAY FOR PULSE METERRemote display for remote control (via max. the reader then displays and sometimes saves that reading in a database. The RDU-1000 is a remote primary display with the ability to communicate with all types of pulse or encoder equipped water meter registers. Pulse output registers put out an incremental pulse with each fixed number of gallons or cubic feet Pulse can be an electrically generated pulse from a powered register, or a contact switch closure with the pulse generated from the reading device through a loop design. Terms of Site Use| And again, a twisted pair from inside CAT5 cable it recommended for this wiring. The connector allows the dedicated programming device to configure and set up the unit. A magnet, contained in the paddle wheel, activates a sensor once per revolution. |Manufacturer Part #VL9, Copyright During initial setup, the initial reading and any special K-Factors are entered into the device using the RCM Programmer. These electric meters can accept the input of up to 3 pulse output devices (such as our water meters). This connector allows the dedicated programming device to configure and setup the unit. Sign up to receive email about product launches, events, deals & more! Compatible withTell me More! The LCD display continually indicates the current meter reading. LEAD LAW WARNING: In accordance with the US Federal or other States laws It is illegal to install products that are not lead free certified in potable water systems anticipated for human consumption. The Omnimeters are powered by 110480 Volts AC. An operator can select the pipe size and schedule from a list using the three embossed buttons on the face of the meter. Pipe mounted flow meter with Remote Display supplied with a 13" long section of 2" schedule 40 PVC pipe. Pipe mounted flow meter with Remote Display supplied with a 13" long section of 1" schedule 80 PVC pipe. The device is programmed through a very simple pocket-sized device known as the RCM Programmer. The PCB is permanently fixed to the inside of the unit under the label and is not removeable. Did you find it helpful? The paddle wheel and associated parts are injection molded from PVC plastic, the paddle pin is stainless steel. electric meters have the ability to read basic, 2-wire pulse output from the water meters.
The counter can be operated with or without a remote re-set function.
Enter your details here for discounts, promotions and more. Compatible withTell me More!
We havePulse-Output Water Metersthat have a pulse output that can be read remotely. Pipe mounted flow meter with Remote Display supplied with a 13" long section of " schedule 80 PVC pipe.
I would like to subscribe to your newsletter. Browse Ferguson's job categories, organized by industry, to find professional-grade equipment, tools and parts for a wide range of projects.
The digits are always displayed and easy to read in low light settings. Midwest Instruments.(715) 523-1268info@micmeter.com, 1/2 Schedule 80 Remote Display Flow Meter, 3/4 Schedule 80 Remote Display Flow Meter, 1.5 Schedule 80 Remote Display Flow Meter, 1.5 Schedule 40 Remote Display Flow Meter. It is powered by 12 Volts DC and comes with a 12VDC power supply for this purpose.
The water meters connect to the Omnimeters via a 2 wire connection (see the Omnimeters spec sheets for detailed wiring instructions). Tamper detection indicates any unauthorized tampering with the wire, meter register and the security sealed cover. Compatible withTell me More! Modified on: Wed, 11 Aug, 2021 at 9:56 AM. The paddle wheel flow meter with remote display, when used in conjunction with the appropriate adapter, can monitor flows in pipes ranging in size from to 8. CAPrivacyRights| A touch reader sends a burst of energy to the meter by electromagnetic induction (similar to wireless phone charging), and the encoder responds with the reading and serial number. Compatible withTell me More! The H2O Degree RDU-1000 is a remote display unit.
Consider these attractively priced, easily installed meters when choosing your next paddle wheel flow meter. Compatible withTell me More! The counter is self powered and is operated by the proximity or reed switch in the meter to which the counter is connected. Water Meter Readers. Please call(715-523-1268) or email (info@micmeter.com) for specific application questions. An ABS enclosure houses the electronics and a scratch resistant polycarbonate faceplate with embossed buttons completes the package. Required State Markings: The serial number, device identification, make, manufacturer and model number are contained on a label that is fixed inside the clear cover that cannot be changed or removed once the unit is sealed. The RCM-100 is a remote primary display with ability to communicate with all types of pulse equipped water meter registers.
Checkout currently unavailable, sorry any inconvenience, Skip to the beginning of the images gallery.